Rapp-it Steel Putty is included with every Rapp-it Pipe Repair Bandage.

Application

1. Roughen and clean the area to be repaired. Cut or twist off required amount.
2. Mix by kneading with fingers to a uniform colour. If mixing is difficult, warm putty to room temperature.
3. Apply to surface within two minutes of mixing. Force into any cracks or holes and strike off excess material.

Application Hints and Tips

• When applying to damp, wet or slowly leaking areas, work the mixed epoxy putty forcefully into the surface and apply pressure until adhesion begins to take effect.
• Use damp fingers for easier mixing, application and a smooth cured appearance. Remove excess material before hardening begins.
• Curing: Steel Putty has a 4-7 minute work life. After 5-10 minutes it hardens and forms a tenacious bond. Final cure occurs in 60 minutes.

Specifications

• Hardness, Shore D (full cure): 75 - 85
• Heat Resistance: 150°C (300°F)
• Chemical Resistance: Resistant to hydrocarbons, ketones, alcohols, esters, halocarbons, aqueous salt solutions, and dilute acids and bases

Read more about Rapp-it Steel Putty:

• Safety Data

For more information on Rapp-it Steel Putty, please contact us.